Sony PCM-3348HR, Руководство по эксплуатации

Страница: 41 / 256

Chapter 3 Basic Operations
3-15
Chapter 3
ARP board
Playing back analog audio channels recorded
on the PCM-3324A/3324
Set the monitor output switch on the ARP board to the
BIAS position.
3-6-3 Analog Audio Channel Playback
Monitoring during insert or assemble
recording
During recording, the input signal is monitored.
Switching the monitor output automatically,
depending on the tape transport state
Press and light the AUTO INPUT button.
The monitor output is then automatically switched
according to the table on page 3-2.
Monitoring with headphones
You can monitor the sound on the analog audio
channels using headphones.
Connect headphones of at least 8-ohm impedance to
the PHONES jack on the ARP board panel. Adjust the
volume with the PHONES LEVEL control.
1
Set the MASTER SAFE switch to the OFF
position.
2
Holding down the SET button, press the A1 A2
REC READY button to set channels A1 and A2 to
the recording ready state.
The A1 A2 REC READY button lights.
3
Holding down the REC button, press the PLAY
button. (If using automatic recording mode, press
only the PLAY button.)
The REC lamps for channels A1 and A2 light, and
recording starts.
Monitor output switch
PHONES LEVEL control
PHONES jack
ARP
OUTPUT
NORM
ADV
COMPANDER
NORM
OFF
LEVEL
PHONES
A2
A1
+
–
+
–
+ –
A2
+
–
A1
+ –
INPUT
LEVEL
OUTPUT
LEVEL
BIAS
PWM