Sony PCM-3348HR, Руководство по эксплуатации

Страница: 123 / 256

Chapter 6 Digital Copy
6-9
Chapter 6
6-4-1 Procedure for Digital Copy
Operation
After completing the channel settings, with the
DIGITAL COPY button still lit, carry out either a
normal insert recording or auto punch in/out operation.
This carries out the digital copy between the selected
pairs of channels.
When the digital copy ends, press the DIGITAL
COPY button, turning it off.
Restoring the channel settings after the digital
copy ends
• In two-channel mode, if you press the DIGITAL
COPY button, turning it off after making the channel
settings, all the channel settings are lost.
• In multi-channel mode, if you press the DIGITAL
COPY button, turning it off after making the channel
settings, the channel settings are preserved. Pressing
the DIGITAL COPY button again, turning it on,
restores the settings.
• You can also carry out normal recording in parallel
with the digital copy operation.
6-4-2 Selecting the Monitor Signal
The following signals are the monitor output signals
during a digital copy.
Monitor output during a digital copy
Channel
Monitor signal
Monitor signal
selection button
Source channel Only the REPRO Source channel tape
button is effective. playback signal
Destination REPRO button Destination channel
channel tape playback signal
INPUT button Source channel tape
playback signal
Other channels REPRO button Tape playback signal
INPUT button Line input signal
Notes on monitor signal settings
• For the source channel, the ALL INPUT button,
AUTO INPUT button, and INPUT button do not
function.
• For the destination channel, all of the monitor signal
selection buttons operate, but even if you select the
input signal monitor state, it is not possible to
monitor the line input signal.
6-4 Carrying Out a Digital Copy
6-4-3 Restoring the Channel
Settings Before the Digital
Copy Operation
Use the following procedure to restore the channel
settings before the digital copy operation.
1
Before pressing the DIGITAL COPY button, use
the buttons in the SET UP MEMORY panel to
save the channel settings.
For details on how to save the channel settings, see the
section “Saving the channel settings” (page 4-8) .
2
Press the DIGITAL COPY button.
This sets all channels to the recording inhibited
state.
3
After setting the source and destination channels,
press the button on the SET UP MEMORY panel
used in step
1
, to recall the channel settings.
This returns the settings of all channels other than
the source and destination channels to their state
before pressing the DIGITAL COPY button.
For details on how to recall the channel settings, see the
section “Recalling the channel settings” (page 4-8) .
If a single channel is set both to the recording
ready state and as a destination channel
If a channel was previously in the recording ready
state, and is thus restored in step
3 above, and is
simultaneously set as a digital copy destination
channel, the destination channel setting takes
precedence.
Restoring the channel settings after the digital
copy ends
When the digital copy ends, and you press the
DIGITAL COPY button, turning it off, all channels go
to the recording inhibited state. To restore the
channels to the state before turning off the DIGITAL
COPY button, first, while the DIGITAL COPY button
is still lit, save the channel settings using the buttons
on the SET UP MEMORY panel. Then after pressing
the DIGITAL COPY button, turning it off, recall the
channel settings from the memory.