Sony KP-41T25 - 41" Color Rear Video Projector, Руководство по эксплуатации

Страница: 41 / 88

Operations
41 -EN
EN
3 1 2
4 5 6
7 8 9
0
ENTER
Operating a cable
box
You can operate a connected cable box with the
supplied remote commander. Before operating, set the
manufacturer’s code number.
1
Set the CABLE BOX/TV selector to CABLE
BOX.
2
While holding down CODE SET, press 0 – 9
to enter the manufacturer’s code number
(see the chart in the right column) and
press ENTER. For example, to operate a
Zenith cable box, press 6 and 8 and press
ENTER.
3
Use POWER (CABLE) and the projection TV
control buttons (0 – 9, ENTER, JUMP and CH
+/–) to operate the cable box.
To operate the projection TV
Set the CABLE BOX/TV selector to TV. Then use the
projection TV control buttons to control the projection
TV.
For more details on operating the cable box
Refer to the operating instructions that come with the
cable box.
Manufacturers and code numbers (cable box)
MODE
Low position
POWER (CABLE)
CODE SET
JUMP
0–9 buttons
ENTER
CH +/–
CABLE BOX/TV
CABLE
POWER
JUMP
CH
Code number
60, 61, 62, 63, 64, 65, 73
69, 70
66, 67
71, 72
68
Manufacturer
JERROLD
PIONEER
SCIENTIFIC ATLANTA
TOCOM
ZENITH
Notes
•
If more than one code number is listed, try entering them one
by one until you come to the correct code for your equipment.
•
If you enter a new code number, the code number you
previously entered at that setting is erased.
•
In some rare cases, your equipment may use a code that is not
provided with this remote commander and you may not be
able to operate your cable box with the supplied remote
commander. In this case, use the equipment’s own remote
control unit.
•
When you remove a battery from the remote commander, the
code may be erased. Reset the code each time you replace the
battery, if necessary.
CABLE BOX TV
6 8
CODE SET
ENTER