Sony IPELA PCS-HG90, Руководство по эксплуатации

Страница: 25 / 200

25
Turning the System On/Off
C
h
apt
er
1:
In
st
al
la
tio
n
an
d Pr
e
p
a
ra
tio
n
• If you use force to prevent the camera moving, it may not resume moving and not
output a signal to the Communication Terminal. In this case, turn off the terminal, and
turn it on again.
• When you turn on the power of the Communication Terminal for the first time after
installation, the setup wizard will appear after the self-diagnosis is completed. Set up
your system following the wizard.
For setups using the wizard, see “Setting Up the System for the First Time
— Initial Setup Wizard” on page 29.
If no picture appears on the TV monitor
The video format of the Communication Terminal is set to “1080/60i” at the
factory. If the video format set on the TV monitor is different from that on the
Communication Terminal, no picture appears on the TV monitor. Check the
video format setting on the TV monitor, and, if necessary, change the video
format setting on the Communication Terminal.
To change the video format on the Communication Terminal
Use the FAR/NEAR button and number buttons 1, 2 and 3 on the supplied
Remote Commander.
When you change the Output Video Format, the system will reboot automatically.
Notes
Video format to be set Operation
1080/60i Press “FAR/NEAR”, then press “1” three times.
1080/50i Press “FAR/NEAR”, then press “2” three times.
720/60p Press “FAR/NEAR”, then press “3” three times.
Note
DISPLAY
PUSH
ENTER
CONNECT/
DISCONNECT
VIDEO INPUT
RETURN MENU
CLEAR SYMBOL
PinP FAR/NEAR
BACK
SPACE
ALPHA/
NUM
FAR/NEAR button
Number buttons 1, 2, 3