Sony Ipela NSR-S10, Руководство пользователя

Страница: 58 / 67

58
Alarm Setting
Cha
p
te
r 4
Det
a
iled Des
c
ript
ion
s
of
Set
tings
and
Win
d
o
w
s
High
Select the cameras for which a “high” sensor status
of the NSR-S10/S20 unit is to trigger an alarm.
Low
Select the cameras for which a “low” sensor status
of the NSR-S10/S20 unit is to trigger an alarm.
IP Camera Sensor
Configure this to use the sensor inputs of the
cameras.
Clicking this displays the “IP Camera Alarm
Setting” screen. Select a camera from the [Camera
List], and select a sensor status ([High] or [Low])
under [Conditions] to the right.
Continuous trigger duration
Enter the number of seconds to wait before
generating an alarm in cases where a sensor status
that triggers an alarm remains continuously.
Abnormal Event
Select this check box to trigger an alarm when the NSR
enters an abnormal state.
Clicking on [Detail] causes the [Abnormal Event]
screen to appear, which can be used to set the
conditions that trigger an alarm.
Select the check boxes of the conditions that are to be
alarm triggers.
Reboot
This generates an alarm when the NSR system
reboots for any reason other than a hardware
abnormality.
Abnormal Reboot
This generates an alarm when the NSR system
reboots due to a hardware abnormality.
Recording is switched off
This generates an alarm when recording is switched
off.
Hard Disk failed
This generates an alarm when a hard disk error
occurs.
D
Alarm Reset
This section sets sensor states which cause the alarm
condition to be released.
High
Select the cameras for which a high sensor status is
to release an alarm.
Low
Select the cameras for which a low sensor status is
to release an alarm.
IP Camera Sensor
Displays the “IP Camera Alarm Setting” screen.
Select the camera and sensor input pin that will act
as the alarm release trigger from the camera list.
E
Action
Select the check boxes for the actions that are to be
performed when an alarm is generated.
Enlarge Camera View
This displays the monitor frame displaying the
specified camera image in the 1 × 1 (1 screen)
layout.
If you select this check box, click [Detail] and then,
when
““Enlarge Camera View” Screen” (page 59)
appears, specify the camera for which the enlarged
image is to be displayed.
Relay Output
This outputs an alarm on a relay output.
If you select this check box, click [Detail] and then,
when
““Alarm Relay” Screen” (page 59) appears,
set the alarm output pin to on or off.