Chapter 7
Setup Menu
Chapter 7
Setup Menu
111
Menu items in the 300s, relating to editing operations
Item number
Item name
Settings
305
SYNC GRADE
When editing in phase-synchronized mode with item 004 set to ON, select the target
phase synchronization accuracy.
ACCUR:
±0 frame accuracy.
ROUGH:
±1 frame accuracy.
307
AUTO-DELETION
FOR
INCONSISTENT
DATA
Select what happens when an erroneous edit point is set.
MANU:
A warning is given by flashing the DELETE button on the control panel.
The operator must manually delete the unnecessary edit point .
NEG&E:
When inconsistent edit points are set, such as when an OUT point is before an
IN (or audio IN) point, or when too many edit points are specified, the previously set edit
point is deleted.
NEG:
When inconsistent edit points are set, such as when an OUT point is before an IN
(or audio IN) point, the previously set edit point is deleted. When too many edit points
are specified, the DELETE button on the control panel flashes to give a warning.
Note
Pressing the button corresponding to an edit point to be deleted and the DELETE button
simultaneously deletes the edit point. If an erroneous edit point is set (the DELETE
button is flashing), editing is not executed.
301
VAR SPEED
RANGE FOR
SYNCHRONIZATION
Select the playback speed range when carrying out playback in variable speed mode
from a remote control unit connected to the REMOTE-IN connector or REMOTE-OUT
connector.
–0.5 ~ 0.5:
–0.5 to +0.5 times normal speed.
–1 ~ +2 :
–1 to +2 times normal speed
306
DMC INITIAL
SPEED
Select the initial speed automatically set when carrying out DMC editing.
MANU :
The speed determined by the rotation of the search dial.
PLAY:
Normal playback speed.
STILL:
Stationary.
±0.03 ~ ±1:
Speed set in the range
±
0.03 to
±
1 (select from
±
1,
±
0.5,
±
0.03,
±
0.2,
±
0.1.)
317
AUDIO EDIT
MODE
Specify the type of editing for audio signals.
CUT:
Cut editing (discontinuity in audio signal may result at the editing point, causing
noise.)
FADE:
Fade out and fade in
IN
OUT
308
SELECTION OF
STD/NON-STD
FOR ANALOG
VIDEO IN
Select the STD or NON-STD mode in accordance with a composite video or S-video
input.
STD:
The STD mode is always used (forced STD mode).
N-STD:
Use this setting when the input video signal is unstable (forced NON-STD
mode).
When using a VCR with no built-in time base corrector (e.g. a home-use VHS-system
VCR), select N-STD.
318
EDIT RETRY
When editing with two DSR-70A/70AP units, set for the recorder. Selects the operation
if the recorder was not synchronized in time.
OFF:
Editing is not carried out, and the unit stops.
ON:
The editing is automatically retried (up to twice).
(Continued)
