78
J-D-F
max. Hold on message
The time over which a limit has to be violated before another message is sent. For example, if a value
of 60 minutes is entered, and the wind speed of a connected anemometer still exceeds the limit value
after 60 minutes, another SMS-warning is sent.
A value of zero deactivates this function.
Value range
Default
Unit
0 … 120
0
min
J-D-G
Hold commander
Time between the last RS-232 communication and the switch-off of the interface. After switch-off a
wake-up sequence activates the interface again.
Value range
Default
Unit
1 … 30
8
sec
J-D-H
Main Switch reset
If activated, the 12-V power supply of the X20 terminal is switched off and on again daily at
. Generally used to reset connected sensors.
Setting
Description
off (default)
Reset is not active
10 sec
Power supply of X20 terminal is switched off for 10 seconds
30 sec
Power supply of X20 terminal is switched off for 30 seconds
J-D-I
Refresh time
The time when the data logger reboots each day. Inactive if no time is set.
Value range
Default
Unit
00:00:01 … 24:00:01
-
-
J-E
Com-1 protocol
A
Device number
0
B
System key
0
C
Output protocol (OP)
Sommer
D
OP, measurement output
just per command
E
OP, wake-up sequence
prefix
F
OP, prefix holdback
300
ms
J-E-A
Device number
Number that uniquely identifies the device in a bus system.
Value range
Default
Unit
1 … 98
0
-
