SOMMER MRL-7, Руководство пользователя

Страница: 100 / 100

99
Appendix E DIP-switches
The counter inputs of the MRL-7 can be configured with three DIP-switches to receive different input
signals. The location of the DIP-switches is shown in
Figure 25 .
Figure 25: DIP-switches
To configure the counter inputs to receive signals from a sensor with either an open collector output
or a source output, set the DIP-switches according to the following table:
DIP-switch Position Function
SW322
(Default)
Pin Wind-Dir on terminal X12 is configured as analog input to re-
ceive a wind direction signal (potentiometer), and pin Counter-2b
on terminal X19 is deactivated.
Pin Counter-2b on terminal X19 is configured as counter input with
a pull-up resistor (connects to a sensor with an open-collector out-
put). Pin
Wind-Dir on terminal X12 is deactivated.
Pin Counter-2b on terminal X19 is configured as counter input with
a pull-down resistor (connects to a sensor with an active output).
SW321
(Default)
Pin Counter-2a on terminal X19 is configured as counter input with
a pull-up resistor (connects to a sensor with an open-collector out-
put).
Pin Counter-2a on terminal X19 is configured as counter input with
a pull-down resistor (connects to a sensor with an active output).
SW320
(Default)
Pin Counter-1 on terminal X10 is configured as counter input with a
pull-up resistor (connects to a sensor with an open-collector out-
put).
Pin Counter-1 on terminal X10 is configured as counter input with a
pull-down resistor (connects to a sensor with an active output).