![background image](http://html.mh-extra.com/html/somfy/rollixo-rts/rollixo-rts_installation-manual_1317447019.webp)
Rollixo RTS
18
Copyright © 2012 Somfy SAS. All rights reserved
EN
Clearing a remote control
Executing "Remote control memorisation" procedures on an already memorised remote control clears it.
Clearing all remote controls
Press button
Prog
on the receiver (for approximately 7 seconds) until the indicator light above it goes out.
Release button
Prog
on the receiver when the indicator light goes out; the indicator light flashes slowly.
All memorised remote controls will be cleared.
Prog
Prog
Prog
Prog
Press and hold down for 7 seconds
Prog
CLEARING thE REMotE CoNtRoLs
MEMoRIsING sAfEty EDGE tRANsMIttERs
Memorising a resistive safety edge transmitter
The transmitter must already be installed and the resistive safety edge
must be connected to the transmitter.
[1].
Press button
Prog
on the receiver until the indicator light comes on
permanently.
[2].
Press the button on the back of the safety edge transmitter 5 times.
The safety edge transmitter indicator light comes on with each press and
after the 5th press remains constantly lit for 4 seconds and then flashes for
4 seconds.
Indicator light 2 on the receiver goes out and the receiver Prog indicator
light will flash and then go out (this may take a few seconds, the time
required for the transmitter and receiver to communicate with each other).
The transmitter is memorised in the receiver.
[3].
Restart the magnet recognition procedure (see page 10).
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
Memorising an optical safety edge transmitter
[1].
Press button
Prog
on the receiver until the indicator light comes on
permanently.
[2].
Using the tip of a pen, press the transmitter PROG push-button for 4
seconds.
Indicator light 2 on the receiver goes out and the receiver Prog indicator
light will flash and then go out (this may take a few seconds, the time
required for the transmitter and receiver to communicate with each other).
The transmitter is memorised in the receiver.
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
x5
Safety edge
Memorising a new radio safety edge transmitter overwrites the previous transmitter.
4s