Rollixo RTS
Copyright © 2012 Somfy SAS. All rights reserved
9
EN
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
[1].
Press button to position the garage door in the upper position.
Ensurethesafetyedgetransmitterisnotfixedtoitsplate.
Installing magnets on the runner
To function correctly, this solution requires the installation of a set of magnets
on the runner
INstALLING AND CoMMIssIoNING A REsIstIvE RADIo sAfEty EDGE
TOP magnet
BOTTOM magnet
Safety edge
transmitter mounting
plate
INstALLING AND CoMMIssIoNING AN oPtICAL RADIo sAfEty EDGE
Memorising the optical safety edge transmitter
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
3
4
2
1
Prog
STOP
[1].
Press button
Prog
on the receiver until the indicator light comes on
permanently.
[2].
Using the tip of a pen, press the transmitter PROG push-button for 4
seconds.
Indicator light 2 on the receiver goes out and the receiver's Prog
indicator light will flash and then go out (this may take a few seconds,
the time required for the transmitter and receiver to communicate with
each other).
The transmitter is memorised in the receiver.
Installing the safety edge and its transmitter
Follow the instructions provided with the optical safety edge transmitter (OSE) and the safety edge installation kit.
4s
[3]. optional
: the lower magnet must be installed if the ground is uneven
and causes erratic obstacle detection.
Press the button to move the garage door to the bottom position,
then secure the lower magnet to the edge of the runner, positioning it
in line with the transmitter.
This operation is important. Ensure the alignment is observed.
Move SW3 dipswitch 1 on the transmitter to ON.
10 mm maxi.
BOTTOM
magnet
1 2 3 4
ON
