SOLZAIMA K100, Инструкция по эксплуатации

Страница: 21 / 184

16
8. Using the free-standing pellet fire
The pellet stoves must be serviced as described in point 3.6, page 151
(Warranty). In order to adjust the operating parameters of the stove (pellet stove), the
dosing must be adjusted as described in point 7 of this manual. The pellet dose must
be adjusted according to the gas temperature and pellet consumption of the appliance
at the rated power described in Table 1, page 5, to ensure that the appliance delivers
the correct power.
Recommendations
Before starting up the unit, please check the following:
- Ensure the unit is properly connected to the power mains using the 230V AC power
cable.
Figure 8 - Electric power plug
Figure 9 - Room temperature probe
- Check if the pellet reservoir is supplied with pellets. Inside the pellet reservoir is a
safety grid to prevent users from reaching the worm screw.
The combustion chamber of the stove and the door are built in steel sheet
painted with high temperature paint, releasing fumes during the first ignition
due to the cure of the paint. Avoid touching the equipment during the first
burn so as not to leave permanent marks on the paint because it’s going
through a more plastic phase during its curing process. The cure of the paint
occurs at about 300 °C for 30 minutes.