Power tool use
ENGLISH
26
Always observe all safety notes and generally all information even in the other chapters of these
operating instructions for any work!
Check list for use (keywords only!) .................................................
è
•
Before start-up:
– Power tool in an operationally safe condition! .......................
è
Operating instructions complete
– Prescribed work clothes ........................................................
è
Chap. 3.3, page 7
– Working area inspected and secured ....................................
è
Chap. 3.2, page 6, and
chap. 3.9, page 10
– Correct cutting disc firmly installed. .......................................
è
Chap. 5.1, page 16, and
chap. 7.1, page 26
– Protective cowl in best position .............................................
è
Chap. 5.4, page 18
– Cutting device position, preferably centre position ................
è
Chap. 5.8, page 21
– Ribbed belt tension correct ....................................................
è
Chap. 5.6, page 20
– Operating media filled in ........................................................
è
Chap. 5.5, page 18
•
Starting: .......................................................................................
è
Chap. 6 complete, as of page 24
– Starting preparations .............................................................
è
Chap. 6.1, page 24
○ Stop dial in operating position ..........................................
è
Chap. 6.1, page 24
•
During work – generally safe work: .............................................
è
Operating instructions complete
– Check idle settings ................................................................
è
Chap. 8.3, page 32
– Inspecting the working situation ............................................
è
Chap. 3.9, page 10,
Chap. 7.2, page 27, and
Chap. 7.3, page 28
– Wet cutting preferred .............................................................
è
Chap. 5.7, page 20
– Secure working technique .....................................................
è
Chap. 7.3, page 28,
chap. 7.4, page 28, and
chap. 7.5, page 29
– Operating and maintenance notes complete .........................
è
Chap. 8 complete, as of page 30
○ Air filter clean ...................................................................
è
Chap. 8.4, page 33
•
After work: ...................................................................................
è
Operating instructions complete
– Cleaning and care .................................................................
è
Chap. 8.1, page 30
– Secure storage of power tool .................................................
è
Chap. 8.10, page 39
– Maintenance ..........................................................................
è
Operating instructions complete
Only use cutting discs that correspond to the standards EN 12413 and EN 13236 and that are
perfectly undamaged.
The approved
maximum speed of the cutting disc must be ≥ 4,450 min
-1
[4,450 rpm].
For processing of metals (hot cutting) and processing of mineral materials (cold cutting), different cutting
discs are offered. Generally, only the cutting disc approved for the material to be processed must be used.
Diamond cutting discs are only approved for cutting mineral materials. When installing the diamond cutting
disc, always observe the rotating direction indicated on the diamond cutting disc; otherwise, the cutting
effect will reduce quickly from diamond loss.
7 Power tool use
7.1 Cutting discs
