Preparing for use
ENGLISH
23
Move water supply line attachment upwards
The water supply line must be placed so that
contact between water supply line and
cutting disc in operation is excluded in all
positions of the protective cowl.
•
Place the water supply line so that it runs on the
outside of the protective cowl and not between
the protective cowl and the assembly flange.
•
Push the attachment screws (a) of the water
supply line into the adapter pieces (b).
•
Place the adapter pieces on the right and left
sides of the protective cowl above the associated
threaded holes (p) and screw in the water supply
line attachment screws.
•
Loosen the screw (q) of the clamp (r) until the clamp can be moved upwards at the blank spar of the top
handle (s).
•
Push the clamp upwards so far that the water supply line can never be in contact with the cutting disc.
•
Check placement of the water supply line when the protective cowl is swivelled all the way to the front
and correct if required.
Install handle for protective cowl adjustment and cutting disc again
•
Install the handle for protective cowl adjustment (3) again to the protective cowl with the respective
attachment screws.
•
Installing the cutting disc:
è
Chap. 5.1, page 16
After production, the power tool is subjected to an inspection and test process that ensures that the motor
is then run in perfectly.
Therefore, no special measures are required for initial commissioning.
5.9 Initial commissioning / run-in behaviour
r
q
3
a
b
p
s
