Preparing for use
ENGLISH
16
The cutting discs used must correspond to the specifications from chap. 7.1 on page 26!
The power tool spindle is designed for cutting discs with an inner bore of 20 mm.
Cutting discs with 1" inner bores must only be installed together with the spindle adapter disc.
Installation of cutting discs with 1" inner bore:
è
Chap. 5.2, page 17!
When using cutting discs with an inner bore of 20 mm, no additional spindle adapter disc is
required.
•
For cutting disc installation, the power tool must be put securely on the ground. Securely hold the power
tool at the top handle with the left hand and push it firmly onto the ground.
è
Chap. 5.4, page 18
•
Insert blocking pin (a) entirely into the cutting disc blocking opening (12) to block the spindle. Screw out
cutting disc attachment screw (11). Remove disc (b) and pressure disc (c).
The rotating direction of the cutting disc is always
as indicated by the arrow above – independently of
whether the cutting device is installed in the centre
or outer position.
•
Put cutting disc (1) on spindle.
For cutting discs with specified rotating direction (arrow on the cutting disc), observe correct alignment
of the cutting disc during assembly (for rotation direction of the cutting disc, see above).
•
Push on pressure disc (c) so that the curved side points southwards, i.e. away from the cutting disc.
5 Preparing for use
5.1 Installing the cutting discs
c
11
b
a
12
1
11
b
c
Rotating direction
of the cutting disc
