Preparing for use
ENGLISH
17
•
Push on disc (b) and turn in cutting disc attachment screw (11).
•
Insert blocking pin (a) entirely into the blocking opening (12) and firmly tighten (30 Nm [22.1 ft·lbf]) the
cutting disc attachment screw (11).
Securely hold the power tool at the top handle with one hand and push it firmly onto the ground.
•
Remove the blocking pin (a).
The power tool's spindle is designed for cutting discs with an inner bore of 20 mm.
For proper installation of cutting discs with a 1" inner bore, the spindle adapter disc is required that
is included with the delivery of the power tool.
The spindle adapter disc ensures correct fit of the 1" cutting disc on the spindle.
•
Installation of cutting discs with 1" inner bore
takes place according to chap. 5.1 as of page 16.
•
After applying the cutting disc on the spindle,
however, the spindle adapter disc (e) must be
put on the spindle (f) additionally.
•
Put the spindle adapter disc (e) onto the spindle
so that it inserts between spindle and inner bore
of the cutting disc.
The support area of the spindle adapter disc
must point outwards in the installed condition, i.e.
away from the spindle.
The correct orientation of the spindle adapter
disc is mandatory to directly connect the plane
inner area to of the pressure disc to the cutting
disc. Only this warrants secure attachment of the
cutting disc.
•
Application of the pressure disc and all following
steps must be performed again according to
chap. 5.1.
•
For cutting disc uninstallation, the power tool must be put securely on the ground. Securely hold the
power tool at the top handle with the left hand and push it firmly onto the ground.
è
Chap. 5.4, page 18
•
Insert blocking pin (a) entirely into the cutting disc blocking opening (12) to block the spindle. Screw out
cutting disc attachment screw (11). Remove disc (b) and pressure disc (c) (also see chap. 5.1).
•
Remove cutting disc from the spindle. For cutting discs with a 1" inner bore, the spindle adapter disc
also must be removed from the spindle.
•
Put the pressure disc back onto the spindle so that the curved side points outward.
•
Put on disc (b) and turn in the cutting disc attachment screw (11) again.
è
Chap. 5.1.
•
Insert blocking pin (a) entirely into the blocking opening (12) and firmly tighten (30 Nm [22.1 ft·lbf]) the
cutting disc attachment screw (11) again.
Securely hold the power tool at the top handle with one hand and push it firmly onto the ground.
•
Remove the blocking pin (a).
5.2 Installing cutting discs with 1" inner bore
5.3 Uninstalling the cutting disc
e
f
