CIE-M10 User’s Manual Ver. 1.1
Sollae Systems Co., Ltd.
- 17 -
http://www. eztcp.com
5.2.2
Configuring Method with ezManager
There are [MAC], [IP], [Serial] tabs in the ezManager according to configuration method. Please
refer to the following table.
MAC
IP
Serial
Media
LAN
LAN
Serial
Method
UDP Broadcast
UDP Unicast
Serial Port
Identification
MAC Address
IP Address
COM Port
Properties
UDP port 50005
UDP Port 50005
115200/N/8/1
Table 5-1 Configuration Method with ezManager
5.2.3
ezManager Buttons
The followings are descriptions about buttons in the ezManager.
Search All
Search for all ezTCP series (including CIE-M10) connected to the local
network. The MAC addresses of each ezTCP will be shown on the
[Search Results] box. (The MAC address of CIE-M10 is written on the
bottom of the product.) The setting values of each ezTCP will be shown
on right side of [Search Results].
Read
Input 6 digit number written on the CIE-M10 to the MAC ADDRESS
input box or Input CIE-M10‟s IP address in the IP address category on
the IP tab. This will allow for the user to read setting parameters for a
specific CIE-M10. When there are too many ezTCPs connected to the
network and it is hard to find a desired ezTCP from the LIST box, this
button may be conveniently used.
Write
After changing the settings, save the changes to ezTCP. CIE-M10 will
automatically reset after the save. Therefore, pressing this button may
cause system shutdown during normal use.
View
Comment
If this check box is checked, ezManager displays CIE-M10‟s nick name
which is set in the Comment.
Open
To read CIE-M10‟s parameters through serial port, open a serial port
which is connected to the CIE-M10 in advance.
Read
(Serial)
Reading parameters from CIE-M10 through the serial port.
Write
(Serial)
Writing parameters to CIE-M10 through the serial port.
Set
CIE-M10 provides user authentication function in order to prevent other
