CIE-M10 User’s Manual Ver. 1.1
Sollae Systems Co., Ltd.
- 13 -
http://www. eztcp.com
4
Getting Started
4.1
Test Operation
4.1.1
PC ‘s IP Address
Change PC‟s IP addresses as followed:
IP Address
10.1.0.2
Subnet Mask
255.0.0.0
Gateway IP address
-
Table 4-1 PC IP
4.1.2
Installing CIE-M10
CIE-M10‟s operating voltage is
DC 3.3V
. You have to use a stable power supplier.
Then the green LED of the RJ45 connector will blink.
4.1.3
Configuring CIE-M10
Using ezManager, change the settings of CIE-M10. Click [Search All] button on the ezManager
window. Then, ezManager will search for every ezTCP on the local network.
When there is no found device, click [Windows Firewall] button on the ezManager window to
check for firewall setting. If this setting is ON, the ezManager could not perform the search.
When CIE-M10 is found, the MAC address of CIE-M10 will be shown on the [Search List]
window. (The MAC address is also written on the bottom of the product case.)
To configure it clearly, please press [Factory Reset] button to reset it with initial values.
