SOLARFOCUS Pelletel Egance 10, Руководство по эксплуатации

Страница: 34 / 48

13 Weatherman function
Deashing in the boiler
Abb. 2-53: Cross section through the boiler
14.1 Required activities - overview
The responsibility for carrying out the maintenance
activities is defined according to type and extent (sys-
tem operator
SO or qualified personnel QP ).
Activity Interval SO QP
Empty ash container > 34
upon noti-
fication
message
[1]
X
Perform boiler cleaning > 35
– Check the stainless steel
combustion grate for wear
> 35
–
Check the stainless steel
combustion grate support
> 36
– Check the combustion
chamber for ash
> 36
monthly
[2]
X
Replace stainless steel com-
bustion grate
> 36
in case of
wear
X
Check system pressure > 37 monthly X
Clean flue gas pipe > 37
six-monthly
[2]
X
Check safety valve > 37 yearly X
Maintenance by qualified per-
sonnel
> 38
yearly X
Perform emissions mea-
surement
> 38
as per
regional
regulations
X
[1] You can use the
E-mail message > 18 function to be informed
about an upcoming emptying of the ash container (see Alarm
selection button)
[2] Indication is valid for average consumption values; adjust the
interval according to your own requirements.
14.1.1 Empty ash container
Empty the ash container when the notification mes-
sage on the boiler control display appears. In the
course of emptying the ash container, a boiler clea-
ning
> 35 can also be performed.
Information on required emptying of the ash con-
tainer:
Abb. 2-54
► Wait until the burner switches off (the burner is
still fulfilling its heating requests normally, i.e. this
may take a while).
►
Open the cladding door.
►
Pull the bar of the retaining device 1 up and
remove the ash container 2 forwards.
► In order to avoid ash coming out, close the ope-
ning on the rear of the container (move slide).
34 Operation manual pelletelegance