5 Use and operation
5 Use and operation
Touch display for operation
If the boiler is supplied with a mains power supply, the
eco
manager-
touch
boiler control starts. The control is
started up to show the main screen.
i
Operate the touch display with your fingers,
do not use any hard or pointed objects.
If no inputs are made for 5 minutes (factory setting),
the display will switch to standby mode.
Tapping the display again restarts the display with the
main screen.
Buffer battery in operating element
A replaceable buffer batter (CR2032) ensures that
data (time, settings) are retained in the operating ele-
ment when the power supply is switched off.
5.1 Main screen of the control
Abb. 2-6: Main screen
1 Software version for control
2 Outside temperature
3 Boiler output (rotational speed of ID fan)
4 Boiler temperature and residual oxygen con-
tent in flue gas
5 Boiler operating mode
6 Status line
Tapping the main screen changes to the
Selection
menu
5.2 Boiler operating mode
1
Chimney sweep function
This function is used to perform the emission mea-
surements prescribed by law.
►
Perform emissions measurement
2
STOP
The burner is switched off. No connected devices
heating requests are fulfilled.
!
ATTENTION
- The burner must not start! Only
the automatic start-up of the heating circuit
pump is active to protect against frost.
3
START
After pressing the
START
button, the burner is ready
for operation, and is able to fulfil heating requests
from the connected devices. The burner goes into
standby as soon as a heating request is fulfilled, or
the time release
is no longer available.
5.3 Selection menu
Abb. 2-7: Selection menu
1 Customer menu
2 Output test heating circuit
CAUTION, only to be undertaken by qualified
personnel.
3 Heating circuit
4 Domestic hot water heating
5 Circulation control (optional)
6 Buffer tank (optional)
7 Solar system (optional)
8 Temperature difference, charge control (optio-
nal)
10 Weatherman function (optional)
11 Information
15 Boiler cleaning
Operation manual
pelletelegance
13
