Softube AAX DSP, Руководство пользователя, Страница: 105 / 182

SOFTUBE USER’S GUIDE | 105
Parameter Display
The display shows the name of the parameter, the
value of the parameter, as well as the previous value.
As soon as you start
to change a parameter,
the display will light up
and the former setting
will be displayed within
the parentheses. While
the display is lit up, the
former setting will not
be over-written.
By clicking on the
parameter display, you
revert the setting to the
previous value.
After one second with-
out changing parameters,
the display will get
dimmed again.
Modulation
Select between three different types of modulation:
RANDOM: Designed to give a lush and uncolored
reverb, without any “pitchy” or “chorus-y” effects.
The default setting for most purposes.
SLOW: A more chorus-like modulation with a slow
modulation rate. Suitable for extremely long reverb
times and legato instruments.
FAST: Same type of modulation as SLOW, but with
a faster modulation rate.
All three types of modulation are based on rand-
omization, but RANDOM is just a bit more random
than the other two...
Reverb Mix
Sets the mix between the direct and effect signal
( early reflections). When using the TSAR-
1 as a send effect, the Reverb Mix should always be
set at 100% (wet). If you use it as an insert effect, a
setting between 15–40% is a good starting point.
Output Volume
The Output Volume affects both the direct and ef-
fect signal. Usually you can just leave it at 0 dB, but
if the output peak meter is going up in the reds it
might be a good idea to lower the volume.
Input and Output Meters
The meters on both sides of the display shows the
input (left hand side) and output (right hand side)
peak levels for both the left and right channel. The
meters have a red indicator at 0 dB.