socomec ISOM Digiware, Инструкция по эксплуатации

Страница: 71 / 84

71 EN
ISOM DIGIWARE - 546780C - SOCOMEC
• Voltage network outside specified range (L-60)
The voltage network connected is outside the working range.
• Device temperature too high (L-60)
The device is overheating (automatically stop the LCI booster)
• Loss of communication (L-60)
The device is no longer connected to a master of the Digiware bus
• Level outside of the operating range (L-60)
IMD measurement is outside the tolerance range and cannot be shown, the L60 is blind
• Core balance transformer disconnected (F-60)
Alarm for detecting the absence of a current sensor
• VI link alarm (F-60)
Alarm for connection error between the current and the voltage
Requires a specific load level: 0.6 < PF < 1 and I> 2% In
• Alert for bad primary TC (F-60)
Configuration error in the primary circuit of the core balance transformer.
11.2. Setting up alarms
The installation alarms are automatically detected and alarms upon events are configured with the Easy Config
software.
There are several ways of identifying the presence of an alarm:
11 .2 .1 . ALARM LED on front
• Flashing: Setup alarm
• Constant: Alarm for an event (takes priority if there is a setup alarm at the same time)
11 .2 .2 . Activation of an output
• On ISOM Digiware L-60 and t F-60, one or more outputs can be activated when an alarm is detected
11 .2 .3 . Acknowledging alarms by input
• If an input is present, the alarm can be acknowledged from this input. Acknowledgement of an alarm can only be
taken into account if the alarm is complete
11 .2 .4 . RS485 Modbus
• Information on the alarms with timestamping available via the RS485 communication bus
• Sends alarm acknowledgement
11 .2 .5 . Display and WEBVIEW
• Information on alarms with timestamping
• Sends alarm acknowledgement