Snorkel UL25, Руководство по запчастям и обслуживанию

Страница: 30 / 94

UL-25/32/40 Portable Personnel Lifts 2-3
Maintenance
Section
2.2
Figure 2-2: Hydraulic Power Unit
1. Motor
2. Pump
3. Reservoir
4. Breather/Dipstick
5. Capscrew (under pump)
6. Grip Plate (under pump)
3
HYDRAULIC OIL RESERVOIR
(Figure 2-2)
Verify that Platform is fully lowered.
1. Remove hydraulic reservoir from pump by removing
four screws and four grip plates.
2. Provide a suitable container (reservoir has a 5,7 liter
[1.5 U.S. gal.] capacity) and dispose of hydraulic fluid
properly; contact your local oil recycler.
Note: Ensure o-ring is in place on pump when install-
ing hydraulic reservoir.
3. Reinstall hydraulic reservoir to pump assembly with
grip plates and screws.
4. Fill hydraulic reservoir through the dipstick hole with
ISO #46 hydraulic fluid. Hydraulic reservoir has a 5,7
liter [1.5 U.S. gal.] capacity. Ensure that oil is visible
on the end of the dipstick.
2.2 Lubrication
Refer to Figure 2-1 for location of items that require
lubrication service. Use an aerosol chain lubricant for all
components to be lubricated that require oil.
CASTERS
Using a grease gun, apply 1 or 2 shots of multi-purpose
bearing grease to each zerk fitting. Swivel casters have
two zerk fittings, one at the wheel bearing and one at the
swivel.
CHAINS
1. Ensure that Platform is fully lowered.
2. Apply enough aerosol chain lubricant to exposed
section of chain to allow lubricant to run down chain.
SCREW JACKS
Apply a moderate amount of aerosol chain lubricant to
each screwjack assembly.
Figure 2-1: Lubrication
1. Chains
2. Casters
3. Rear Wheels
4. Screw Jacks
1
2
5&6
4