Snorkel UL25, Руководство по запчастям и обслуживанию

Страница: 16 / 94

Transporting the Work Platform
Operation Manual Page 9
DC M
ODELS
Disconnect the plug from the battery box and
remove the battery box from the rear of the
machine.
The battery box is heavy, 23,6 kg (52 lbs.). Lift
properly to prevent back injury.
Refer to Figure 6: “Loading the UL for Transpor-
tation,” on page 10.
Make sure the loader fully engages the tailgate or
vehicle bed.
1. Raise the loader support brackets and engage
the retaining pin in the top hole of the loader
channel.
2. Secure the loader to the loader support bracket with the gravity hook.
3. Position the unit so the back of the machine comes into contact with the tailgate or vehicle bed.
4. Release the gravity hook and slide the loader down until it comes into contact with the tailgate or vehicle
bed. Then reposition the loader support bracket so that the retaining pin is in the first available hole
above the loader.
5. Release the locking pin and pull the T-handle out until the locking pin engages the hole in the end of the
T-handle.
6. Lift up on the T-handle, using the loader as a pivot, until the unit rotates to a horizontal position in the
vehicle bed.
7. Push the base of the unit towards the front of the vehicle bed. The machine will slide on the loader until
the rear wheels are on the bed. The unit may then be rolled on the rear wheels and upper casters.
8. Return the T-handle to the stored position, making sure that the locking pin engages the T-handle.
9. Secure the unit with suitable tie straps using the forklift pockets located under the base of the unit, and
either the upper caster axle on the UL25 models or the tilt back frame on the UL32 and UL40 models.
To prevent damage to the mast assembly, do not place rope or tie straps across the mast assembly when
securing the unit for transportation.
DO NOT overtighten the rope or tie straps or damage to the machine will result.
Charger
Battery Box Plug
Battery Box (DC Models Only)
! !
! !
CENTRE OF GRAVITY
and be certain that forklift is of adequate capacity to lift the machine.
Forklift from the rear by lifting from fork pockets.
BY TRUCK
1. Maneuver the machine into transport position and
chock wheels.
2. Secure the machine to the transport vehicle
with chains or straps of adequate load capacity
attached to the chassis lifting/tie down points.