Snorkel UL25, Руководство по запчастям и обслуживанию

Страница: 31 / 94

2-4
Maintenance
Section
UL-25/32/40 Portable Personnel Lifts
2.2
2.3 Battery Maintenance
(DC units only)
Electrical energy for the motor is supplied by a 12-volt
battery. Proper care and maintenance of the battery and
motor will ensure maximum performance from the lift.
Hazard of explosive gas mixture. Keep
sparks, flame and smoking materials away
from batteries.
Always wear safety glasses when working
with batteries.
Battery fluid is highly corrosive. Rinse away
any spilled fluid thoroughly with clear water.
BATTERY INSPECTION AND
CLEANING
Check battery fluid level daily, especially if work platform
is being used in a warm, dry climate. If required, add
distilled water only; use of tap water with high mineral
content will shorten battery life.
If battery water level is not maintained,
battery will not fully charge, creating a low
discharge rate which will damage Motor/
Pump unit and void warranty.
Battery should be inspected periodically for signs of
cracks in the cases, electrolyte leakage and corrosion of the
terminals. Inspect cables for worn spots or breaks in the
insulation and for broken cable terminals.
Clean battery that shows signs of corrosion at the termi-
nals or onto which electrolyte has overflowed during
charging. Use a baking soda solution to clean the battery,
taking care not to get the solution inside the cells. Rinse
thoroughly with clear water. Clean battery and cable
contact surfaces to a bright metal finish whenever a cable
is removed.
BATTERY CHARGING (Figure 2-3)
Charge battery at end of each work shift or sooner if
battery has been discharged.
Charge battery in a well-ventilated area.
Do not charge battery when the lift is in an
area containing sparks or flames.
Permanent damage to battery will result if
battery is not immediately recharged after
discharging.
Never leave charger operating unattended
for more than two days.
Never disconnect cables from battery when
charger is operating.
Keep charger dry.
When night air temperatures fall below 18
°
C (65
°
F) a battery
charged in an unheated area should be placed on charger as
soon after use as possible. Under such conditions a 4 hour
equalize charge once a week in the early afternoon will
improve state of charge and battery life.
1. Check battery fluid level. If electrolyte level is lower than
10 mm (
3
/
8
in.) above plates add distilled water only.
2. Verify charger voltage switch is set to 12 volts.
3. The battery charger is located at the rear of the mast. Connect
extension cord (1,5 mm
2
[12 gauge] conductor minimum and
15 m [50 ft.] in length maximum) to the charger plug.
Connect other end of extension cord to properly grounded
outlet of proper voltage and frequency.
4. Set charger control to "conventional" setting. Charger
ammeter should indicate charge rate.
5. When battery is fully charged, charger automatically
turns itself off. Disconnect extension cord.
2.3