LC2000/LC2000-IQ/LC4000/LC4000-IQ
Safety Information
Issue 1 Rev 6
Page 6
© 2015 SAM
Mains Power Supplies
This equipment has two 3-pin IEC power sockets, one for the main power supply unit and one
for the redundant power supply unit.
The power supply is auto switching for input voltages in the ranges of 100 V to 240 V nominal.
No voltage adjustment procedure is required.
Power Cord Supplied
The equipment is shipped with a power cord with a standard molded IEC female plug on one
end and a standard mains plug on the other. If you are required to remove the molded mains
supply plug, dispose of the plug immediately in a safe manner.
The color code for the cord is as follows:
•
GREEN/YELLOW lead connected to E (Protective Earth conductor)
•
BROWN lead connected to L (Live Conductor)
•
BLUE lead connected to N (Neutral Conductor)
Laser Safety
This product operates with Class 1 laser products.
Ventilation
Although the unit is constructed to meet normal environmental requirements, ensure that
there is a free flow of air at the front, rear, and sides of the unit to dissipate the heat produced
during operation. Installations should be designed to allow for this.
•
This equipment has more than one power supply. To reduce the risk of electric
shock, plug each power supply into separate branch circuits employing separate
service grounds.
•
Before performing any servicing or maintenance, disconnect and isolate the unit
from the mains input and from any product outputs.
•
Do not operate this unit without an earth connection.
Caution: Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
Do not obstruct the ventilation holes on the right-side of the unit. Damage to the equipment
may result.
