Snapmaker A150, Быстрый старт

Страница: 20 / 41

32
|
Quick Start Guide
|
33
3D Printing
3.1.2 Initial Setup
Plug the AC Power Cable into an electrical outlet. Switch the power on and follow the prompts on the
touchscreen: Read the Terms -> Name the Machine -> Connect to a Wi-Fi Network.
Guides & Pictures / Snapmaker
3.2.1 Calibrate the Bed
How It Works: Auto Leveling
The 3D printing module conducts a compensation leveling procedure, with the sensor measuring the distance
between the nozzle and the heated bed at specific points. The movements of the extruder are adjusted to
ensure that the nozzle and the heated bed are at an optimum distance throughout the printing process.
How It Works: Adjusting the Z Offset
Z Offset is the distance between the tip of the nozzle and the print surface. Adjusting the Z Offset is the
process of tweaking the height of the nozzle by tiny increments. A proper Z Offset value helps ensure the first
layer of your print sticks to the print sheet.
Guides & Pictures / Snapmaker
0.1 mm
Filament
Too Low Too High
Print Sheet
It is recommended to wait for 5 seconds when you turn your machine off and on again.
Please skip this step if you
have completed the initial
setup. If you need to change
the settings above, swipe
left on the home page of
the touchscreen -> select
Settings -> tap Wi-Fi or
About Machine as needed.
The initial guide, which
helps you get started, will
appear only once. If you
need to launch it again,
swipe left on the home page
of the touchscreen -> select
Settings -> tap Guides .