S E C T I O N 5
•
O u t o f t h e B o x - A s s e m b l y
Level 1
®
NORMOFLO
®
H-1129 Irrigation Fluid Warmer | Operator’s Manual
9
Step 2 - Assemble Fluid Warmer to Base
1
Insert two locking casters (
e
) into the base as shown, and then insert
the two non-locking casters. Bring the base upright; then remove the
3 screws (
c
) from the Base Assembly.
2
With the power cord on the Base Assembly facing forward, gently
slide the Fluid Warmer/Pole Assembly (
a
) onto the Base Assembly
(
b
).
Note: Do not drop the Fluid Warmer/
Pole Assembly onto the Base
Assembly.
3
Re-install the three screws (
c
) and tighten using the 1/8 inch Allen
wrench supplied.
Note: Take care not to strip the screw threads.
4
Plug the power cord from the Base Assembly into the Auxiliary
Outlet (
f
) on the bottom of the Fluid Warmer/Pole Assembly (
a
).
5
Turn valve, located on the bottom of the device, perpendicular to
stem (
g
) of the Fluid Warmer as shown.
6
Remove 61 cm (24”) black tubing from its package. Push one end of
the tubing into the opening of valve stem (
h
) until it can go no
further; gently pull the tubing to make sure it is secure.
7
Remove one J-clip from its package and peel off the backing to
expose the adhesive. Adhere the J-clip to the back of the Fluid
Warmer, approximately 13 cm (5”) above the valve stem.
8
Push the tubing into the J-clip.
a
b
c
e
e
f
g
h
