7
product is decommissioned it must not be dumped in the environment; it must be disposed of in accordance with
the relevant regulations. All metal parts are in stainless steel and can be removed. The plastic parts are marked
with the symbol identifying the material used and must be disposed of in accordance with the relevant
regulations. When the product is decommissioned it must not be dumped in the environment; it must be
disposed of in accordance with the relevant regulations. All metal parts are in stainless steel and can be removed.
POSITIONING:
4 INSTRUCTIONS FOR TECHNICAL STAFF
4.1
lumbing hookup
Water supply and drain connection
The water pipelines and electricity supply cable lead out of the bottom
right-hand corner of the appliance. Connect the water intake hose to a
connector with
¾”
threaded fitting, fitting the filter
A
provided (in models
with acquastop, the filter and ring-nut form a single unit).
The connection to the water mains must only be made with new hoses; the
use of old or worn hoses is not permitted.
FOR MODELS WITH A WATER SOFTENER
AN ‘APPROVED’ DOUBLE CHECK VALVE OR SOME OTHER NO LESS EFFECTIVE DEVICE PROVIDING
BACKFLOW PREVENTION PROTECTION TO AT LEAST FLUID CATEGORY TWO SHALL BE FITTED AT THE
POINT OF CONNECTION BETWEEN THE WATER SUPPLY AND THE FITTING OR APPLIANCE.
FOR MODELS WITHOUT A WATER SOFTENER
AN ‘APPROVED’ SINGLE CHECK VALVE OR SOME OTHER NO LESS EFFECTIVE DEVICE PROVIDING
BACKFLOW PREVENTION PROTECTION TO AT LEAST FLUID CATEGORY TWO SHALL BE FITTED AT THE
POINT OF CONNECTION BETWEEN THE WATER SUPPLY AND THE FITTING OR APPLIANCE.
The dynamic water
supply
pressure
must be between
1 and 6 bar
; if it is higher a pressure reducer
must be installed. It is essential to fit a main stop tap on the water intake deliver pipeline; the tap
must be accessible after installation of the appliance, so do not install it behind the warewasher. The
stated cycle duration applies to appliances supplied with
hot water >50°C<60°C
If the warewasher is
supplied with cold water, the cycle duration might increase depending on the intake water
temperature. The warewasher
is fitted with a drain pump
and can operate with drain connections
on the floor or wall. Refer to the connection diagram for the maximum permitted height of wall
drains – (see TECHNICAL DATA)
Caution:
the indoor system and premises in which equipment for institutions is installed
must comply with the relevant regulations.
The manufacturer declines all liability for direct or indirect injury or damage deriving from failure
to comply with these regulations. Before installation, check that there are no objects or materials
in the vicinity which may be damaged by steam or splashes of washing solution, or that any such
items are suitably protected. Place the glasswasher in the chosen point and remove the protective
film. Level the glasswasher (with the aid of a spirit level) on its adjustable feet to ensure that it is
stable; all other mounting solutions must be approved by the manufacturer.
Содержание PROFESSIONAL GLASSWASHER
Страница 1: ...PROFESSIONAL GLASSWASHER ...
