Smeg PROFESSIONAL GLASSWASHER, Руководство по эксплуатации

Страница: 30 / 31

29
13
MALFUNCTIONS SHOWN ON THE DISPLAY (FOR
THE USER)
The glasswasher is able to identify a number of malfunctions and show them on the display.
If the problem persists after the glasswasher has been switched off and back on, proceed as described
below:
(TO ALLOW THE AFTER-SALES SERVICE TO TAKE THE APPROPRIATE ACTION, ALWAYS MAKE A NOTE OF
THE ERROR INDICATED)
Err01
The anti-flooding system has been
activated (for the relevant models
only).
Contact the After-Sales Service.
Err04 Tank temperature probe malfunction Contact the After-Sales Service
Err05 Tank water filling malfunction
Check that the water intake tap is on and the dynamic
pressure in intake system, inspect water intake filter and
clean if necessary. If the problem persists, contact the After-
Sales Service.
Err06
Water pump-out malfunction
(glasswasher is left full of water)
Inspect the filters for dirt and check that the drain hose is not
blocked, bent or crushed.
Check that the drain pump is not blocked by dirt; proceed as
described in point “10.2 Periodic checks”. If the problem
persists, contact the After-Sales Service.
Err09 Tank water level too high
Contact the After-Sales Service.
Err23
Boiler heating malfunction (does not
heat up)
Contact the After-Sales Service.
Err24 Boiler temperature probe malfunction Contact the After-Sales Service.
Err25 Boiler water filling malfunction
Check that the water intake tap is on and the dynamic
pressure in intake system, inspect water intake filter and
clean if necessary. If the problem persists, contact the After-
Sales Service.
Err26 Boiler emptying malfunction
Check that the rinsing spray arm nozzles are not fouled If the
problem persists, contact the After-Sales Service.
Err27
Boiler emptying malfunction – with
tank full
Contact the After-Sales Service.
Err28
Boiler heating malfunction
(overheating)
Contact the After-Sales Service.