Doc. no.IZ
＊
-OMV0005
15
The bracket mounting methods are shown below.
a. Mounting the product to the bracket
If angle adjustment is required after fixing the
product, use the elongated holes in the bracket. If it
will not be required use the round holes.
For mounting the product to the bracket, use the
hexagon socket head cap screws (M3 x 6) and flat
washers included with the bracket.
Refer to "Dimensions" section for details.
Tightening torque: 0.61 to 0.63 Nm
b. Mounting of the bracket
For mounting the bracket to an installation etc.,
use either the through holes or tapped (M3) holes
and use the elongated or round holes in the base of
the bracket. When angle adjustment is necessary
after installation, use the elongated holes.
If the elongated holes are used, the flat washers
included with the bracket must be used.
The mounting screws should be prepared by the
user.
Refer to "Dimensions" section for details.
Mounting angle adjustable range of the L-bracket
(2) Pivoting bracket
a. Mounting of the product to the bracket
For mounting the product to the bracket, use the
hexagon socket head cap screws (M3 x 16) included
with the bracket.
Tightening torque: 0.61 to 0.63 Nm
b. Fixing of the bracket
For mounting the bracket to an installation etc., use the elongated holes or round holes.
If the elongated holes are used, the flat washers included with the bracket must be used.
The mounting screws should be prepared by the user.
Refer to "Dimensions" section for details.
Mounting angle adjustable range of the pivoting bracket
Round hole
Elongated hole
Avoid interfering with piping.
Elongated holes
Round holes
Elongated holes
Round hole
M3
M3
90
o
