-8-
No.D-
※
S-OMG0006-C
Environment
Do not use in a location where magnetic fields are generated.
Products will malfunction or the magnets inside actuators will become demagnetized.
Do not use in an environment where the product will be continually exposed to water.
Although products satisfy the IEC standard IP67 construction, do not use in applications continually exposed to
water splashes or spray. Otherwise, insulation failure or malfunction may result.
Do not use in an environment where oil or chemical splashes can occur.
If products are used in an environment with coolants, cleaning solvents, oils or chemicals for even a short time, they
may be adversely affected by insulation failure, malfunction due to swelling of the potting resin, or hardening of the
cable.
Do not use in an environment where there are cyclic temperature changes.
Temperature cycles other than normal temperature changes can adversely affect the product internally.
Avoid accumulation of iron debris or close contact with magnetic substances.
When a large amount of iron waste such as machining chips or spatter has accumulated, or a magnetic substance
(something attracted by a magnet) is brought into close proximity with the actuator, it may cause the product to
malfunction due to a weakening of the magnetic force inside the actuator.
Contact SMC for information regarding product water resistance, elasticity of cables, applications in
welding sites, etc.
Do not use in direct sunlight.
Do not mount the product in locations where it is exposed to radiant heat.
The product is CE marked, but not immune to lightning strikes. Take measures against lightning strikes in
the system.
Do not use in a location where surges are generated.
When there are units (solenoid lifter, high frequency induction furnace, motor, etc.) which generate a large amount of
surge in the area around the actuator with solid state auto switches, this may cause damage to the product internal
circuit
Do not install this product in a place subject to vibration and impact. (980 m/s
2
or less for the sensor unit,
98 m/s
2
or less for the amplifier unit)
The internal parts can be damaged leading to malfunction even if the product body is not damaged.
Take appropriate measure to prevent freezing when the operating temperature is 5
o
C or less.
Maintenance
Do not use solvents such as benzene, thinner, alcohol etc. to clean the product.
This may damage the surface of the body or erase the markings on the body.
For heavy stains, use a cloth soaked with diluted neutral detergent and fully squeezed, then wipe up the stains again
with a dry cloth.
