-25-
No.D-
※
S-OMG0006-C
●
Setting procedure 2
<<Verify 4 work pieces below using Air Gripper (MHZ2 series)>>
[A]
Work piece size is correct
[B]
Work piece size is too large
[C]
Work piece size is too small
[D]
No work piece
(1) Hold the minimum conformant work piece by supplying air to the gripper.
(2) Insert the sensor unit up to the end of the mounting groove. (Figure below)
: The relationship between OUT1 and OUT2 is reversed if the mounting direction is opposite. The Detection range may change.
An Operation check with actual equipment should be performed as the location of OUT1 and OUT2 is reversed depending on the air
gripper structure.
This is an example for setting.
Perform the setting and operation check with actual equipment.
