-20-
No.D-
※
S-OMG0006-C
●
Setting procedure 1
<<Verify 4 work pieces below using Air Gripper (CQ2 series)>>
[A]
Work piece size is correct
[B]
Work piece is too large
[C]
Work piece is too small
[D]
No work piece
(1) Push the largest conformant work piece by supplying air to the actuator.
(2) Insert the sensor unit up to the end of the mounting groove. (Figure below)
: The relationship between OUT1 and OUT2 is reversed if the mounting direction is opposite. The Detection range may change.
An Operation check with actual equipment should be performed as the location of OUT1 and OUT2 is reversed depending on the
cylinder structure.
This is an example of setting.
Perform the setting and operation check with actual equipment.
