![background image](http://html1.mh-extra.com/html/smc-networks/ce2/ce2_user-manual_1299285047.webp)
44
9-3 Selection of Dip Switch
No.1
・・・
The Identification of Origin
OFF
・・・・
When cylinder stops, if there is no signal feedback from sensor within t1 (Preset data,P7),
counter value will be reseted to
“0” and origin is obtained / recognized.
Generally, origin will be at the stroke end.
If origin is set within the stroke, install stopper with respect to the origin.
ON
・・・・・
When the cylinder stops at origin, situated at the location where auto switch or limit switch
is, and sensor signal is not feedback within t1, counter value will be reset to
“0.0” and
origin is obtained.
Install the origin wire to terminal 10.
No.2
・・・
The Setting of Braking System
OFF
・・・・
In this state, ON means brake is activated. OFF means brake is in releasing state.
If power supply of controller is cut off, the brake will be in releasing state.
If cylinder is mounted horizontally and the air balance is not achieved, when power is cut
off, the cylinder may keep moving in and out.
If cylinder is mounted vertically, when power is cut off, cylinder rod will fall to the bottom
end, due to its own weight.
ON
・・・・・
In this state, OFF means brake is activated, ON means brake is in releasing state.
If power supply of controller is cut off, the brake will be in clamping state.
Note: Please take note at piping, which may lead to opposite setting.
No.3
・・・
The Change of Counter Direction
OFF
・・・・
The extend direction will be an increment on counter.
The origin is set to be at the retract end.
ON
・・・・・
The retract direction will be an increment on counter.
The origin is set to be at the extend end.
Note: Please take note at wiring as it may result to opposite
setting.
No.4
・・・
Delection of Memory: Delete all the input data, back to the initial state.
Generally, set the state to OFF. If input data is required to be deleted, set the state to ON. Next,
reset the power supply through terminal 13. After achieving the initial state, set the state back to
OFF.
10. Driving
10-1 Setting of Origin Direction
Location
’s detection method used by Monosashi-kun with brake cylinder is incremental method. Please
set the origin and reference accordingly.
Cylinder stroke end, either extend end or retract end, will be the origin. When dealing with cylinder with
cushion, please do not over monitoring the cushion effect.
When stopper is used, please use shock absorber to prevent from the occurrence of impact and
“spring
back
” effect.
Retract End
Extend
Extend End
Retract
Содержание CE2
