SMC Networks 6152PL2 FICHE, Руководство по управлению

Страница: 655 / 818

Spanning Tree Commands
4-277
4
Example
The following example configures the switch to use Rapid Spanning Tree:
This command configures the spanning tree bridge forward time globally for this
switch. Use the
no form to restore the default.
Syntax
spanning-tree forward-time seconds
no spanning-tree forward-time
seconds - Time in seconds. (Range: 4 - 30 seconds)
The minimum value is the higher of 4 or [(max-age / 2) + 1].
Default Setting
15 seconds
Command Mode
Global Configuration
Command Usage
This command sets the maximum time (in seconds) the root device will wait
before changing states (i.e., discarding to learning to forwarding). This delay is
required because every device must receive information about topology
changes before it starts to forward frames. In addition, each port needs time to
listen for conflicting information that would make it return to the discarding
state; otherwise, temporary data loops might result.
Example
This command configures the spanning tree bridge hello time globally for this switch.
Use the
no form to restore the default.
Syntax
spanning-tree hello-time time
no spanning-tree hello-time
time - Time in seconds. (Range: 1-10 seconds).
The maximum value is the lower of 10 or [(max-age / 2) -1].
Default Setting
2 seconds
Console(config)#spanning-tree mode rstp
Console(config)#
Console(config)#spanning-tree forward-time 20
Console(config)#