SMC Networks 6152PL2 FICHE, Руководство по управлению

Страница: 307 / 818

Link Layer Discovery Protocol
3-251
3
Web – Click LLDP, Configuration. Enable LLDP, modify any of the timing parameters
as required, and click Apply.
Figure 3-145 LLDP Configuration
CLI – This example sets several attributes which control basic LLDP message timing.
Configuring LLDP Interface Attributes
Use the LLDP Port/Trunk Configuration to specify the message attributes for
individual interfaces, including whether messages are transmitted, received, or both
transmitted and received, whether SNMP notifications are sent, and the type of
information advertised.
Command Attributes
• Admin Status – Enables LLDP message transmit and receive modes for LLDP
Protocol Data Units. (Options: Tx only, Rx only, TxRx, Disabled; Default: TxRx)
• SNMP Notification – Enables the transmission of SNMP trap notifications about
LLDP and LLDP-MED changes. (Default: Enabled)
This option sends out SNMP trap notifications to designated target stations at the
interval specified by the Notification Interval
in the preceding section. Trap
Console(config)#lldp 4-343
Console(config)#lldp refresh-interval 60 4-345
Console(config)#lldp holdtime-multiplier 10 4-343
Console(config)#lldp tx-delay 10 4-346
Console(config)#lldp reinit-delay 10 4-345
Console(config)#lldp notification-interval 30 4-344
Console(config)#lldp medFastStartCount 6
4-344
Console(config)#exit
Console#show lldp config
LLDP Global Configuation
LLDP Enable : Yes
LLDP Transmit interval : 60
LLDP Hold Time Multiplier : 10
LLDP Delay Interval : 10
LLDP Reinit Delay : 10
LLDP Notification Interval : 30
.
.
.