SMC Networks 6152PL2 FICHE, Руководство по управлению

Страница: 158 / 818

Configuring the Switch
3-102
3
• Re-authentication – Sets the client to be re-authenticated after the interval
specified by the Re-authentication Period. Re-authentication can be used to detect
if a new device is plugged into a switch port. (Default: Disabled)
• Max-Request – Sets the maximum number of times the switch port will retransmit
an EAP request packet to the client before it times out the authentication session.
(Range: 1-10; Default 2)
• Quiet Period – Sets the time that a switch port waits after the Max Request Count
has been exceeded before attempting to acquire a new client.
(Range: 1-65535 seconds; Default: 60 seconds)
• Re-authentication Period – Sets the time period after which a connected client
must be re-authenticated. (Range: 1-65535 seconds; Default: 3600 seconds)
• Tx Period – Sets the time period during an authentication session that the switch
waits before re-transmitting an EAP packet. (Range: 1-65535; Default: 30 seconds)
• Intrusion Action – Sets the port’s response to a failed authentication.
- Block Traffic – Blocks all non-EAP traffic on the port. (This is the default setting.)
- Guest VLAN – All traffic for the port is assigned to a guest VLAN. The guest
VLAN must be separately configured (See ?$paratext>? on page 3-222) and
mapped on each port (See ?$paratext>? on page 3-117).
• Authorized – Displays the 802.1X authorization status of connected clients.
- Yes – Connected client is authorized.
- No – Connected client is not authorized.
- Blank – Displays nothing when dot1x is disabled on a port.
• Supplicant – Indicates the MAC address of a connected client.
• Trunk – Indicates if the port is configured as a trunk port.
Web – Click Security, 802.1X, Port Configuration. Modify the parameters required,
and click Apply.
Figure 3-61 802.1X Port Configuration