HGM8151 Genset Parallel Controller User Manual Page 45 of 66
9
SENSORS SETTING
─
When reselect sensors, the sensor curve will be transferred into the standard value. For example, if
temperature sensor is SGX (120°c resistor type), its sensor curve is SGX (120°c resistor type); if
select the SGD (120°c resistor type), the temperature sensor curve is SGD curve.
─
When there is difference between standard sensor curves and using sensor, user can adjust it in
“curve type”.
─
When input the sensor curve, X value (resistor) must be input from small to large, otherwise,
mistake occurs.
─
If select sensor type is set as “none”, sensor curve is not working.
─
If corresponding sensor has alarm switch only, user must set this sensor as “none”, otherwise,
maybe there is shutdown or warning.
─
The headmost or backmost values in the vertical coordinates can be set as same as below,
Fig.2 Curve Setting
Table 17 Normal Pressure Unit Conversion
Unit
pa
kgf/cm
2
bar
psi
1Pa
1
1.02x10
－
5
1x10
－
5
1.45x10
－
4
1kgf/cm
2
9.8x10
4
1
0.98
14.2
1bar
1x10
5
1.02
1
14.5
1psi
6.89x10
3
7.03x10
－
2
6.89x10
－
2
1
