SMART SmartBoard 600 Series, Руководство пользователя

Страница: 37 / 56

99-00850-21 A0 Maintaining Your 600i2 Interactive Whiteboard System 29
To replace the projector plate assembly on the projector boom
1. Complete the last step of the replacement projector lamp instructions.
2. Attach the projector plate to the projector using the three screws you
removed from the projector plate assembly.
3. Put the projector plate assembly back on the projector boom, by attaching
the projector plate hinge channel to the corresponding flange hook on the
projector boom.
4. Hold on to the projector plate assembly firmly when raising the assembly.
5. Raise the projector plate assembly, while keeping it attached to the
flange hook. Pass the threaded rod through the attachment hole
on the projector boom. Secure the projector by attaching and
screwing the thumbscrew you removed from the projector plate
assembly to the threaded rod.
6. Plug in the power cord and all the connector cables.
7. Turn on the projector’s master power switch, then press the power
button on the ECP to start up the system.
8. You may need to realign the image after you have replaced the
projector plate assembly. Turn the thumbscrew to adjust the level
position, while firmly holding the projector. Refer to the
installation
guide for further adjustment instructions.
To reset the lamp timer
1. After you turn the system back on, press the up button on the remote control for approximately 10
seconds. When the projector beeps, press the down button on the remote control for approximately 10
seconds. The lamp timer clears after another beep.
2. To confirm that the lamp timer has been reset, press the MENU button on the remote control. Scroll to the
Status Display menu heading, and confirm that OH appears in the Lamp timer field.
3. After confirming that the lamp timer has been reset, put the system in Standby mode by pressing the power
button on the ECP.
4. Wait for the system to enter Standby mode, and then turn off the projector’s master power switch to shut off
the system. Then turn on the projector’s master power switch.
5. When you are ready to use the system, press the power button on the ECP to start up the system.