SMART SmartBoard 600 Series, Руководство пользователя

Страница: 19 / 56

IMPORTANT
99-00850-21 A0 Before Installing Your 600i2 Interactive Whiteboard System 11
4. Remove the mirror housing compartment panel on the front of the
boom. This panel has the SMART Technologies logo on it. Locate the
three numbered fine adjustment wheels in the mirror housing
compartment.
5. If your image has a vertical keystone, adjust the #1 screw-wheel on
the mirror support. Turn the wheel clockwise to rotate the mirror up
slightly (use this if the projected image is shorter on the top of the
screen and larger on the bottom) and turn the wheel counter-
clockwise to rotate the mirror down slightly (use this if the projected
image is larger on the top of the screen and shorter on the bottom).
6. If your image has a horizontal keystone, adjust the #2 screw-wheel
on the mirror support. Turn the wheel clockwise to rotate the mirror to
the right slightly (use this if the projected image is larger on the left of
the screen and shorter on the right) and turn the wheel counter-
clockwise to rotate the mirror to the left slightly (use this if the
projected image is larger on the right side of the screen and shorter
on the left).
7. Slide the interactive whiteboard left or right to align
it with the image.
8. Using the supplied 6 mm hex key, turn the hex
screw marked #3 to adjust the image size. This
adjustment controls how the image fills the screen
and has been fit to minimize your adjustment after
installation. Turn the key clockwise to make the
image smaller and counter-clockwise to make the
image larger.
9. Adjust the image focus using the control lever on
the projector (next to the status indicator lights).
Slide the focus lever to the left or right to bring the
image to focus.
For the following instructions, leave a 3/8" (1.0 cm) margin between the projected image and
each outer edge of the screen’s surface. Don’t extend the image to the edge of the screen’s
surface.