Smart Caregiver TL-2015R2, Инструкция по установке и эксплуатации

Страница: 15 / 29

15
Eg.
Then, use Caregiver key to cancel the “Delete” operation, or use A-Key to conirm the “Delete” operation. After
conirmed the “Delete”, it shows “Erasing…” and then back to the record showing.
Delete all records:
To delete all records, move it to “Erase All” under the “Cordless PAD” menu. Use Caregiver Key to conirm the
erase operation. It shows “Erasing…” also and then quit to show “Add Rec. “.
- Quit Cordless PAD setup mode
Move it to show “<Quit>”, use Caregiver key to quit this function, and go up to main menu selection.
7.4.2 Normal User Operation
The irst time a new pad is used (after being programmed in as above) the TL-2015R2 will show that this pad has
been added to the working list memory. The TL-2015R2 is now checking this pad continuously looking for the
handshake signal every 30 seconds. If it does not see this signal for 10 minutes it will show the pad lost signal
and the user should check this pad.
- Make “Add”
Pressing on the PAD, the TM-04 will then output “PAD-ON” message. The TL-2015R2 then shows
“Added” message and add it into the PAD’s working list.
- Make “Alarm”
After added into the TL-2015R2 working list, TL-2015R2 will monitor its state. When the PAD released,
TL-2015R2 will output alert.
- Make “Return”
Re-press the PAD again, TL-2015R2 gets the “Return” message and shows it out on the display.
- Make “Lost”
When TL-2015R2 cannot receive the RF message from the speciic TM-04, for about 10 minutes, it
then shows “Lost” message.
Reset PAD-Lost
## Room Bed S/N
* 01 ?1 ? ????
## Room Bed S/N
* 01 01 1 1234
Delete ?
“C-Key”