Smart Caregiver TL-2015R2, Инструкция по установке и эксплуатации

Страница: 12 / 29

12
Turning “off” this OORC switch will automatically clear the fault checking memory of the central monitor and it
will cease to respond to any periodic fault checking signals from ield equipment.
(note: You should check that each unit on the system is working correctly after the OORC has been turned off
and you should do a routine check of the system).
The next section is the new section added to allow the new CordLess
®
pad function to work
with The TL-2015R.
7.4 CordLess
®
PAD operation
The cordless PAD function is implemented in “menu” style. It uses Caregiver key and “Acknowledge” button
(A-Key) to operate this function.
7.4.1 Register the CordLess ® PAD
To use a cordless PAD, you must irst is to register its ID in to TL-2015R2. So it needs the following functions to
operate the registration.
- Enter into setup mode (You must use the caregiver key for this)
Press the A-Key and also put C-Key on the “Key” position at the same time, wait about 6 seconds, TL-2015R2 will
beep 2 sounds and then release both C-Key and A-Key, it will enter into the setup mode.
There are two options in the setup menu, “Cordless PAD” or “Clock Time”, the irst item is the “Cordless PAD”.
On this menu, press A-Key to show next item, and C-Key to confirm the selection.
Select “Cordless PAD” for cordless PAD registration.
- Record cordless PAD (The maximum number of cordless pads is 30 = nn below)
Under “Cordless PAD” menu, 3 options for selection, “Add Rec.”, “List Rec. [nn]” and “Erase ALL “. The irst is the
“Add Rec.”.
Wireless
TL-2015R2
SETUP V1.6
:> Cordless Pad
Cordless Pad
:> Add Rec.