Page 39
INE S.p.A.
Via Facca, 10 - 35013 Cittadella - PADOVA - ITALIA Tel. 049/9481111 - Fax 049/9400249 - [email protected] - www.ine.it
15.2 Settings for TIG welding
The operating mode switch ‘S1’ allows the choice of
the welding mode.
•
Press switch selector ‘E1’ for a while; the relevant
led will start blinking.
•
Turn the selector until the led corresponding to the
TIG LIFT or TIG HF
welding blinks (confirmation is
automatic after 5 seconds of inactivity).
Con il selettore ‘E5’ è
possibile impostare in ogni
momento la corrente di
saldatura (in Ampere) e la
medesima è visualizzata sul
display ‘D1’.
Display ‘D1’ also shows, while
welding, the measured
voltage and current.
To select the operating mode:
•
Press switch selector ‘E1’ for two times; the relevant
led will start blinking.
•
Turn the knob until the led corresponding to the
mode wanted starts blinking. From the top left:
2-step (
ÇÈ
), 4-step (
ÇÈÇÈ
)
, 3-level or USER
mode
(confirmation is automatic after 5 seconds of
inactivity).
2-step mode:
the welding process starts when
pressing the torch pushbutton, and stops when
releasing it after the descent ramp has been executed
and the post-gas time is finished.
4-step mode:
by pressing the torch pushbutton, the
welding process starts with a manual pre-gas; when
releasing it, actual welding will start. Upon the next
pressure of the torch pushbutton, the welding current
makes, if set, the descent ramp and then it will stop,
while the gas continues flowing; upon releasing it, the
gas flow will stop too.
3-level mode
]
:
when the torch trigger is pressed,
the welding process begins at the current value set with
parameter ‘
Start cur
’ (see explanation below). When
the torch trigger is released, the current will rise up to
the value set with ‘E5’. When the torch trigger is
pressed again, the current will drop down to the value
set with parameter ‘
Crater cur
’ (see explanation
below). When the torch trigger is released again, the
welding process will stop.
H
SI
L
G
N
E
OK
ESC
V
A
kmp 5000
D1
E4
E5
MMA
TIG HF
MIG P
MIG DP
MIG
USER
E1
Содержание KMP3200
Страница 63: ......
