SkyLine KMP3200, Руководство по эксплуатации

Страница: 28 / 64

Page 26
INE S.p.A. Via Facca, 10 - 35013 Cittadella - PADOVA - ITALIA Tel. 049/9481111 - Fax 049/9400249 - ine@ine.it - www.ine.it
7 Maintenance
Any repair work or replacement of spares
should be carried out by skilled personnel,
qualified to operate on electromechanical
systems.
Welders are allowed to remove the side
panels of the welding machine
(after
disconnecting it from the mains) only to
remove any dust or dirt that may have been
taken in.
This operation must be executed with a jet of
compressed air (free of humidity and oil) at least every
three months, or more frequently in case of working in
quite dusty environments.
Check each day that there are no powder deposits and
broken pieces of wire on the wire feeder. If this is the
case, clean carefully so as to avoid any electric contact
with the wire feeder body.
8 Electromagnetic compatibility (EMC)
INE welding machines are conceived for use in
industrial applications only (CLASS A of CISPR11). If
they are used differently (e.g. for domestic use), they
may cause compatibility problems, as they may
interfere with other electrical appliances operating in
the vicinity (radios, phones, computers, etc.).
It’s the user’s responsibility to install the power source
and use it in the proper places so that no EMC problems
may arise. When judging the suitability of a workplace,
the presence of the following should be considered:
•
telephone lines and sets
•
receiving and transmitting radio/TV sets
•
computers and control devices
•
safety devices
•
measuring instruments.
Special attention should be paid to people with
pace-makers and similar bio-electronic devices since
they may be influenced by electromagnetic fields.
These people are strongly suggested to keep away
from any places in which welding is going on.
In the event electromagnetic disturbance should occur,
it’s the user’s responsibility to solve the situation; INE,
as the manufacturer of the welding set in use, is ready
to assist.
For further information please refer to EN 60974-10
(Enclosure A, particularly) which regulates the matter in
the EEC.
This system complies with IEC standard 61000-3-12,
on condition that the maximum impedance (Zmax)
admitted to the system itself is lower than or equal, at
the point of interface between user system and public
system, to:
95 m W (KMP3200)
107 m W (KMP5000)
It is a responsibility of the installer or of the user of this
system to assure, in case by consulting the electric
energy distribution company, that the system itself is
connected to a power supply with correct impedance.
H
SI
L
G
N
E