Sirona DAC PROFESSIONAL, Руководство по обслуживанию

Страница: 12 / 66

Maintenance instruction and protocol
DAC Professional
5 Static Check
5.1 General instructions / Safety instructions
⇒
For the following service work, it is recommended to remove the lower part of the rear
wall of the device, in addition to the housing. The DAC Professional will remain fully
functional after these parts are removed. Warning: Be sure to observe the relevant
safety precautions that must be observed for operating the device without the rear wall
and the housing.
5.2 Check the levelling of the autoclave
⇒
Check to make sure the autoclave has been set up and positioned properly to slope to
the rear. Starting from a level position, the front feet of the autoclave must be screwed
three (3) turns for the DAC Professional. The autoclave must slope to the rear to ensure
that the residual water and condensate will properly flow out toward the rear.
O
Levelling was o.k.
O
Levelling corrected
5.3 Check of the chamber and the tray rack
⇒
Check the chamber and the tray rack for dirt / rust.
The chamber should be checked at every use by the practice personnel.
Cleaning the chamber is not a part of the maintenance!
O
Chamber / Tray rack were clean
O
Chamber / Tray rack must be cleaned
O
Chamber / Tray rack have been cleaned
5.4 Check the door gasket
⇒
Check the door gasket (rubber seal) to make sure that it is not damaged. Clean if
required with a mild commercial liquid cleaning agent (pH = 5 … 8; the agent must NOT
contain vinegar), or with spirits (alcohol).
O
Gasket was clean
O
Gasket was cleaned
O
Gasket has been exchanged
______________________________________________________________________
______________________________________________________________________
5.5 Adjustment of the door locking mechanism
⇒
See Instructions in the Service manual“
O
Adjustment performed
5.6 Check / grease the door lock
⇒
Check the door lock for wear or defects. Lubricate with plain silicone grease.
O
Door lock greased
O
Following parts were exchanged: ________________________________________
09/21/2006 10/61 Servicemanual DAC Professional