Sirona CEREC MC XL Premium Package, Руководство по эксплуатации

Страница: 58 / 78

63 98 536 D 3439
58
D 3439
.
201.06.10
.
02 10.2017
7 Service Dentsply Sirona
7.4 Instruments Operating Instructions CEREC MC XL Premium Package
7.4.2 Changing instruments
1. In the software, go to the system menu and click on the
"Configuration"
button.
2. Click the
"Devices"
button.
3. Click on the unit whose instruments you wish to replace.
4. Click the
"Change Instruments"
button.

If two sets are activated:
A dialog box then opens where you can select the set, whose
instruments should be replaced.
5. If necessary, select the desired set.
You can also select the desired set on the touch display of the unit.
6. Click the
"Start"
button on the PC or on the touch display.

The motors travel to the change position for the instruments.
The dialog box for changing the instruments opens.
7. Press the catch of the processing chamber door and open the door.
8. Loosen the worn-out or defective instrument with the torque wrench
and pull it out manually.
9. NOTICE! Do not grease instruments without chuck! Insert the new
instrument into the motor mount by hand. Tighten the corresponding
chuck with the torque wrench until a clicking sound can be heard.
NOTICE
Instruments without chuck
In order to ensure that no grease residue from previously used chucks
remains in the clamping cone when using instruments without a chuck,
we strongly recommend degreasing the clamping cone.
NOTICE
Regular replacement of the instruments
Change the instruments as soon as the system prompts you to do so.
- Milling instruments (wet grinding): Typically after no more than around
25 restorations. The type of material, block size and processing options
may affect the service life.
- Shaper 25 (dry milling): After 50 restorations.
- Shaper 25 RZ (wet milling): After 30 restorations.
- Finisher 10 (dry and wet milling): After 50 restorations.
CAUTION
Risk of injury on instruments
If you put your hand in the processing chamber, you could injure it on
the instruments.
Be careful not to brush against the instruments with your hand.
Apply the torque wrench as shown.