16
CONNECTION TO THE POWER SUPPLY
INSTALLATION DIAGRAM
BASIC ADJUSTMENT OF SENSOR TO THE
AMBIENCE
• Connections may be carried out by a
qualified technician only. The earthing
protection must comply with the standing
regulations.
• Connection terminals are revealed when the
connection box cover is removed.
• Prior any attempted connection check that
the voltage indicated on the rating plate is in
line with your home power supply.
• The rating plate is located underneath the
appliance.
• The cooking hob operates at 220V-240V~.
In order to make a fixed connection to
the mains, insert an all-pole circuit breaker
between the appliance and the mains. This
device shall have a contact separation in
all poles, providing full disconnection under
over-voltage category III conditions.
• Such appliances are allowed to be mounted
on one side next to a high kitchen cabinet,
the height of which may exceed that of the
appliance. On the opposite side however,
only a kitchen cabinet of equal height as the
appliance is allowed.
• Upon the completion of installation, live wires
and isolated cables must be adequately
protected against accidental touching.
• Cooktops models SDDH1.1 are equipped
with power cables.
• The connection needs to be made on the
terminals of the power cable directly during
the connection with the electrical net as you
can find both in the rating plate and in the
electrical scheme here below.
Before attempting any repairs on the appliance,
disconnect the power supply. In accordance
with the mains voltage the appliance should be
connected in line with the attached diagram.
The earthing wire (PE) must be connected to the
terminal marked with the earthing symbol.
The connection cable must lead through the
relief safety device, protecting it from accidental
pulling out.
Upon each connection to the power supply
the sensors of the appliance are automatically
adjusted to the environment to ensure their
proper function. All displays turn on and are fully
illuminated for a few seconds.
During the adjustment procedure the sensors
must be free of any objects, otherwise the
adjustment procedure will be interrupted until
such objects are removed from the sensor
surface. During this period the regulation of the
cooktop is impossible.
WARNING
Содержание S-DDH1.1
