8
INSTALLATION OF INTEGRATED
INDUCTION DOWNDRAFT
BUILT-IN INDUCTION HOB
OPENING DIMENSIONS
• The installation and the connection of the product
to the mains electricity must only be carried out
by qualified personnel.
• The kitchen unit into which the product is to be
installed must be realised in materials (including
adhesives and finishes) that are resistant to a
temperature of 100°C.
• After the installation, the product must be
accessible for any servicing requirements.
• Overhead cabinets must be a minimum of
800mm for installaton or removal of downdraft
section.
• The cornice of the worktop can have a thickness
greater than the worktop because an opening is
maintained in the front part of the kitchen unit of
at least 5mm (refer to design below) to ensure an
adequate passage of air to avoid overheating the
product.
• Before cutting the hole, check inside the kitchen
unit where the product will be housed to ensure
that there are no obstructions such as parts of
the unit’s structure or anything else that could
cause problems for a correct installation. Check
that the overall dimensions of the downdraft and
the cooking hob are compatible with the kitchen
cabinets so that the installation is feasible.
• Induction hob may be built into the 25 to 40
mm thick worktops.
S-DDH1.1
A
898mm
B
510mm
C
860mm
D
490mm
E
45
F
5
G
50
CAUTION
Содержание S-DDH1.1
