SineDigital MW-1500AP(H), Руководство по установке

Страница: 24 / 28

SineDigital,Inc. Installation Guide for MW-1500AP(H)
Entire contents 2003
SineDigital,Inc
.
All rights reserved
Page 24
AccessPoint> snmp
Insufficient parameters.
ex) snmp manager <primary server(trap destination) ip> <secondary server ip>
snmp manager 211.50.55.210 0
snmp manager 211.50.55.210 211.50.55.211
ex) snmp community <read-community> <write-community> <trap-community>
snmp community public1 public2 public3
ex) snmp on
ex) snmp off
ex) snmp trap
ex) snmp trapon
ex) snmp trapoff
ex) snmp trap all
ex) snmp filter enable/disable
ex) snmp filtermanager <server ip 1> <server ip 2>
snmp filtermanager 211.50.55.210 0
snmp filtermanager 211.50.55.210 211.50.55.211
AccessPoint>
(17) sntp
The SNTP (Simple Network Time Protocol) function is used to synchronize the MW-
1500AP(H)'s time with the time received from a specified time server. With the command
sntp ,
you will be able to configure whether or not to use the SNTP function, the time server's IP
address, and the time period loop (in seconds) after which the MW-1500AP(H) will receive
such time information.
AccessPoint> sntp
Insufficient parameters.
ex) sntp [enable/disable]
ex) sntp addr [server ip]
ex) sntp time [time interval to get time from time server]
ex) sntp timeoffset [time offset value in hours from GMT]
AccessPoint>
(18) syslog
This command determines whether or not to save the MW-1500AP(H)'s System Log. The
saved System Log can be displayed by typing the command
show syslog at the prompt.
AccessPoint> syslog
Syslog enable
Insufficient parameters.
ex) syslog [enable/disable]
AccessPoint>