SineDigital,Inc.
Installation Guide for MW-1500AP(H)
Entire contents 2003
SineDigital,Inc
.
All rights reserved
Page 23
(15) show
This command is used to verify the configuration status and statistical information of various
functions and parameters of the MW-1500AP(H). The available commands are shown below.
show aaa
: Shows information regarding 802.1x authentication.
show http
: Shows configuration status of the MW-1500AP(H)'s HTTP.
show interface
: Shows overall information of the MW-1500AP(H)'s interface.
show rf
: Shows configuration status of the MW-1500AP(H)'s RF.
show snmp
: Shows configuration status of the MW-1500AP(H)'s SNMP.
show syslog
: Shows MW-1500AP(H)'s current System Log.
show systime
: Shows MW-1500AP(H)’s current System time.
show trap
: Shows transmission status of each SNMP TRAP in the MW-1500AP(H).
(16) snmp
The following are commands for the configuration of the MW-1500AP(H)'s SNMP (Simple
Network Management Protocol) function. Typing the command
show snmp
will display the
current configuration status of the MW-1500AP(H)'s SNMP.
snmp manager <primary server(trap destination) ip> <secondary server ip>
: Up to two
SNMP Managers can be configured. Only configured SNMP Managers can access the
SNMP Set operation.
snmp community <read-community> <write-community> <trap-community>
: SNMP
community can be configured. Only those clients with the same community name as the
one configured will be able to connect with the MW-1500AP(H).
snmp off
: Disables the MW-1500AP(H)'s SNMP function.
snmp trap
: Displays a menu where you can enable/disable SNMP trap and assigns how
many times the trap message will be sent.
snmp trapoff
: Disables SNMP trap function.
snmp trap all
: Enable/disable each SNMP trap transmission the MW-1500AP(H) can send.
